Fujitsu PRIMERGY TX100 S3 Maintenance Manual page 163

Ê Reconnect all external cables to the replaced expansion card.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 59.
Ê Enable the PCI slot of the replaced expansion card as described in section
"Enabling replaced components in the system BIOS" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 83.
Ê After replacing a network controller in a server running Linux OS,
the NIC configuration file in a Linux environment" on page
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
The following notes are required for TX100 S3p (PYT10Pxxx for Japanese
market).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê After installing or replacing a Modular RAID controller, update the firmware
as described in section
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page
TX100 S3
"Connecting the server to the mains" on
"Looking up changed MAC / WWN addresses"
161.
"Updating RAID controller firmware" on page
82.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Note on network
85.
78.
"Updating
80.
75.
"Enabling
163