Replacing Memory Modules; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

10.4

Replacing memory modules

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
Average software task duration: 5 minutes

10.4.1 Required tools

Preliminary and concluding steps: tool-less
●
Replacing memory modules: tool-less
●

10.4.2 Preliminary steps

Before replacing a memory module, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section
page 45.
Ê Locate the defective expansion card using diagnostics information as
described in section
TX100 S3
69.
"Disconnecting power cord" on page
"Using diagnostics information" on page
Upgrade and Maintenance Manual
Main memory
"Disabling BitLocker
"Shutting down the server" on
"Removing the side cover" on
41.
43.
209