Removing 3.5-Inch Hdds; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Hard disk drives
7.3

Removing 3.5-inch HDDs

Customer Replaceable Units (CRU)
Average task duration: 5 minutes
7.3.1

Required tools

Preliminary and concluding steps: tool-less
●
Removing a 3.5-inch HDD: tool-less
●
7.3.2

Preliminary steps

Before removing a 3.5-inch HDD, perform the following steps:
Ê Ensure that the HDD to be removed is not combined into a RAID array. If the
drive is part of a RAID array, you first need to delete the array using
ServerView RAID Manager.
V
CAUTION!
All data on all HDDs in the array will be lost! Be sure to back up your
data before deleting a RAID array.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide, available online at
http://manuals.ts.fujitsu.com (EMEA market) or
http://jp.fujitsu.com/platform/server/primergy/manual/
market) or from the ServerView Suite DVD 2 supplied with your
PRIMERGY server.
Ê Shut down the server as described in section
page 42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the side cover as described in section
page 45.
118
"Disconnecting power cord" on page
Upgrade and Maintenance Manual
(Japanese
"Shutting down the server" on
"Removing the side cover" on
43.
TX100 S3