Installing A Replacement Fbu; Concluding Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

9.3.6.5

Installing a replacement FBU

Ê Install the new FBU into the FBU holder as described in section
the FBU" on page
Ê Install the FBU holder into the chassis as described in section
FBU holder into the chassis" on page
Ê Connect the FBU adapter cable to the TFM as described in section
"Connecting the FBU adapter cable to the TFM" on page
9.3.6.6

Concluding steps

Perform the following procedures to complete the task:
Check carefully the cable routing and close the cable clamps.
Ê
Ê Close the side cover as described in section
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 59.
Ê If applicable, update the firmware of the RAID controller that has been
connected to the FBU as described in section
firmware" on page
TX100 S3
175.
"Connecting the server to the mains" on
75.
Upgrade and Maintenance Manual
Expansion cards and backup units
177.
"Installing the side cover" on
"Updating RAID controller
"Preparing
"Installing the
178.
189