Concluding Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Main memory
Figure 124: Installing memory modules (C)
Ê Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.

10.2.4 Concluding steps

Perform the following procedures to complete the task:
Ê Close the side cover as described in section
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 59.
Ê If available, update the system board BIOS to the latest version as described
in section "Updating the system board BIOS" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
206
"Connecting the server to the mains" on
82.
Upgrade and Maintenance Manual
"Installing the side cover" on
73.
"Enabling
TX100 S3