4.7
Removing the HDD cage
4.7.1
Preliminary steps
Before replacing the system fan module, perform the following steps:
Ê Shut down the server as described in section
page
42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the side cover as described in section
page
45.
Ê Remove the HDDs as described in section
page
118.
I
Take care, that you notice all detached cables for future reconnecting.
Figure 19: Remove the screws
Ê Remove the four screws (see circles).
TX100 S3
"Disconnecting power cord" on page
Upgrade and Maintenance Manual
Basic hardware procedures
"Shutting down the server" on
"Removing the side cover" on
"Removing 3.5-inch HDDs" on
43.
61