Expansion cards and backup units
9.3.5
Replacing a BBU
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
V
CAUTION!
Do not throw battery backup units into the trash can. Batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section
protection" on page
9.3.5.1
Required tools
Preliminary and concluding steps: tool-less
●
Replacing a BBU: tool-less
●
9.3.5.2
Preliminary steps
Before replacing a BBU, perform the following steps:
Ê Shut down the server as described in section
page
42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section
page
45.
9.3.5.3
Removing a BBU from the chassis
Ê Remove the BBU module from the chassis as described in section
"Removing a BBU" on page
184
38.
"Disconnecting power cord" on page
179.
Upgrade and Maintenance Manual
"Environmental
"Shutting down the server" on
"Removing the side cover" on
43.
TX100 S3