7.2
Installing 3.5-inch HDDs
Customer Replaceable Units (CRU)
Average task duration: 5 minutes
7.2.1
Required tools
Preliminary and concluding steps: tool-less
●
Installing a 3.5-inch HDD: tool-less
●
7.2.2
Preliminary steps
Before installing a 3.5-inch HDD, perform the following steps:
Ê Shut down the server as described in section
page
42.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the side cover as described in section
page
45.
Ê Locate the correct installation bay as described in section
for 3.5-inch HDDs" on page
TX100 S3
"Disconnecting power cord" on page
106.
Upgrade and Maintenance Manual
Hard disk drives
"Shutting down the server" on
"Removing the side cover" on
"Mounting order
43.
107