Removing A Memory Module; Concluding Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Main memory

10.3.3 Removing a memory module

Ê Identify the desired memory slot according to the mounting order described
in section "Memory sequence" on page
V
CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Operation modes" on page
Figure 125: Removing memory modules
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory module connector (1).
Ê Remove the ejected memory module (2).

10.3.4 Concluding steps

Perform the following procedures to complete the task:
Ê Close the side cover as described in section
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 59.
Ê If available, update the system board BIOS to the latest version as described
in section "Updating the system board BIOS" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
208
203.
"Connecting the server to the mains" on
82.
Upgrade and Maintenance Manual
202.
"Installing the side cover" on
73.
"Enabling
TX100 S3