Removing A Memory Module; Installing A Memory Module; Concluding Steps - Fujitsu PRIMERGY TX100 S3 Maintenance Manual

Main memory

10.4.3 Removing a memory module

Ê Identify the defective memory slot using the server management software.
Ê Remove the defective memory module as described in section
memory modules" on page

10.4.4 Installing a memory module

Ê Replace the defective memory module as described in section
memory modules" on page

10.4.5 Concluding steps

Perform the following procedures to complete the task:
Ê Close the side cover as described in section
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 59.
Ê If available, update the system board BIOS to the latest version as described
in section "Updating the system board BIOS" on page
Ê Enable the replaced memory module(s) as described in section
replaced components in the system BIOS" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
210
207.
204.
"Connecting the server to the mains" on
82.
Upgrade and Maintenance Manual
"Installing the side cover" on
73.
78.
"Removing
"Installing
"Enabling
"Enabling
TX100 S3