Copying Existing Laser Settings To A New File; Deleting A Laser File - Christie CP4440-RGB Installation And Setup Manual

Copying existing laser settings to a new file

Copy an existing laser file when to create a new file with similar settings.
1. In the left navigation menu, select Laser Settings > Laser Power/LiteLOC Setup.
2. Select the Display White Test Pattern slider.
3. From the Laser File list, select the file to copy.
4. To save the new laser file, select Save As.
5. Enter a new name for the laser file and then select Save.
6. Adjust the maximum expected temperature and power settings as required for the new
configuration.

Deleting a laser file

Delete a laser file when the configuration is no longer required.
1. In the left navigation menu, select Laser Settings > Laser Power/LiteLOC Setup.
2. Select the Display White Test Pattern slider.
3. In the Laser File list, select the file to delete.
4. Select Delete.
5. To confirm the deletion, select Delete.
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Managing the light source
73