Installing The Maintenance Kit - Xerox DocuPrint N3225 System Administrator Manual

Installing the Maintenance Kit

Installing the Maintenance Kit

The Maintenance Kit is comprised of these items:
• Fuser Cartridge
• Bias Transfer Roll (BTR)
• 15 feedrolls (three for each paper input tray)
The Fuser Cartridge, feedrolls and BTR have expected
useful lives of 300,000 impressions. Printing can continue
beyond this point. However, to ensure optimum print
quality the Maintenance Kit should be replaced as soon as
possible after 300,000 impressions from the previous kit
installation. To ensure optimum print quality you should
order and replace the Maintenance Kit as soon as possible.
This section describes how to replace the Maintenance
Kit.
All three items of the Maintenance Kit should be replaced at
the same time to maintain a consistent maintenance cycle. It is
your responsibility to install the Maintenance Kit to keep the
machine in optimal condition. It is also your responsibility to
determine when this kit installation is required. Your service
representative can be called to install this kit for a fee.
Loose toner may get on your hands during this procedure. You
can use the supplied cleaning pad to clean your hands after
completing the installation.
The Fuser area becomes extremely hot during use of the
printer. Be sure to power OFF the printer and let it cool
for at least 15 minutes before replacing the Fuser
Cartridge.
Chapter 4: Maintaining the Printer 4-9