Finisher
6-56
System Administrator Guide
Hold the Paper Transport parallel to the ground
13
and unfold the two brackets under the Paper
Transport edge nearest to the printer by pulling
on the green tabs. Rotate them into place by
turning them down and to the side as shown
and push them snugly against the retainers.
Use caution when moving the finisher to
ensure that it does not tip over.
14
Slide the finisher towards the printer until its
GFI power cord and connector cable can easily
reach the printer easily.
15
Fully extend the Guide Rail that is attached
underneath the printer and align it with the
Guide Rail slot under the finisher. Make sure
the Guide Rail is completely inserted into the
guide rail slot under the finisher and is aligned
with the plate and hole underneath the right
hand side of the finisher.
16
Pass the finisher GFI power cord behind the
Emissions Bracket Assembly and plug it into the
printer, as shown.