2.
Peel off a strip of tape. Stretch the tape across the table with the sticky side up.
Fasten it to the table at both ends.
3.
Remove the roller.
4.
Roll the roller across the tape to remove the debris from the roller.
5.
Locate a clean section of the tape, rub it onto the surface of the pick pad for the
paper tray, then remove it.
6.
Replace the roller.
7.
Reinsert the tray.
Drum Temperature Sensor
With a dry swab, clean any buildup around the drum temperature sensor. You can
access the sensor through the opened exit cover. Also make sure the sensor rides
evenly on the drum surface. You can remove the sensor, if necessary, to clean under it.
Maintenance
Maintenance Kit
The printer uses the Maintenance Kit as part of its self-maintenance routine to coat
the print drum with oil before each print.
Maintenance Kit Life
Standard/Startup
Maintenance Kit Life
Any Coverage*
Extended
Maintenance Kit Life
0 - 20% Coverage*
20 - 100% Coverage*
*The image coverage is determined by counting the number of pixels imaged.
Service Manual
10,000
30,000
20,000
7-5