Output Timeout - Xerox DocuPrint N3225 System Administrator Manual

Using the Finisher

Output Timeout

Table 1.37 Output timeout operation
Destination
Requested
Finisher Bin 1, 2, or 3
Finisher Bin 1
Finisher Bin 1
Finisher Bin 2
Finisher Bin 2
Finisher Bin 3
Finisher Bin 3
1-134 System Administrator Guide
Table 1.37 defines printer operation, based upon the
Output Timeout setting, when the requested finisher bin
is full. The Output Timeout setting can be selected from
the System Menu. If the Output Timeout setting allows
printed output to be redirected to an alternative bin, that
bin is used until the original output bin again becomes
available. This occurs when the original requested finisher
bin is emptied. Printing is redirected to the original bin at
the next job boundary. If the current job was re-directed
to an alternative bin, the re-direction remains in effect
until the last page of the job becomes available.
Timeout
Value
OFF Display shows "Bin Full". Printer waits until the Bin is emptied.
0 Immediately changes destination to Bin 2. If Bin 2 is full, output
is directed to Bin 3.
5, 10, 30, or 60 Display shows "Bin Full" until the Timeout expires. After the
seconds Timeout expires, subsequent pages are directed to Bin 2. If Bin
2 is full, output is directed to Bin 3.
0 Immediately changes destination to Bin 3. If Bin 3 is full, output
is directed to Bin 1.
5, 10, 30, or 60 Display shows "Bin Full" until the Timeout expires. After the
seconds Timeout expires, subsequent pages are directed to Bin 3. If Bin
3 is full, output is directed to Bin 1.
0 Immediately changes destination to Bin 1. If Bin 1 is full, output
is directed to Bin 2.
5, 10, 30, or 60 Display shows "Bin Full" until the Timeout expires. After the
seconds Timeout expires, subsequent pages are directed to Bin 1. If Bin1
is full, output is directed to Bin 2.
Action