Using The Hard Disk Drive For Secure And Proof Jobs; Creating Secure Jobs - Xerox DocuPrint N3225 System Administrator Manual

Using the Hard Disk Drive for
Secure and Proof Jobs

Creating Secure Jobs

Using the Hard Disk Drive for Secure and Proof Jobs

Secure, collated copy, and proof jobs that have been
submitted to the printer are stored in PCL or PostScript
format on the Hard Disk Drive. These secure and proof
jobs can be printed (or deleted) through the Password
Menu where you enter the 4-digit password for the job or
jobs to be printed. Procedures for printing or deleting
secure jobs are listed in Table 3.8 on page 3-21.
The secure or proof job is placed at the top of the print
queue, and will print following completion of the
currently printing job. If more than one job is requested,
jobs are placed on the print queue in the order requested.
Secure or proof jobs having the same priority are printed
on a first in, first out basis.
Secure printing delays printing of a job until a password
associated with the job is entered at the printer's Control
Panel. Entering the password at the Control Panel will
provide access to only those jobs sent with that password.
Secure jobs are normally created in PCL and PostScript by
choosing the feature in a driver. When not using a driver,
secure jobs may be created by preceding the job with the
following PJL commands:
@PJL XSECUREJOB
@PJL XJOBPASSWORD = "number"
These commands must be immediately followed by a
standard PJL "JOB" command that includes the
"jobname."
Chapter 3: Using the Hard Disk Drive and Flash Memory 3-9