Memory Modules
Memory Modules
6-40
System Administrator Guide
This section contains two sets of instructions:
• "Installing" (page 6-41)
• "Removing" (page 6-43)
These instructions are for installing either DRAM or Flash
memory modules.
Memory modules and the printer's controller board are
sensitive to static electricity. Before installing or removing
modules, discharge static electricity from your body by
touching something metal, such as the metal back plate on
any device plugged into a grounded power source. If you
walk around before finishing the procedure, again
discharge any static electricity.
Never remove the printer controller board while the printer
is plugged in.