Removing
Follow the procedure below to remove the interface card.
To remove the card you will need either a Phillips head
screwdriver or a hex head nut driver.
1
2
3
4
Chapter 6: Installing and Removing Printer Options
Power OFF the printer.
Disconnect the GFI power cord from the printer.
Discharge any static electricity from your body
before continuing with the next step.
Loosen the thumbscrews and pull out the controller
board. Set it on a flat surface.
Use the screw driver/nut driver to remove the two screws
that hold the interface card in place as illustrated. Set the
screws aside.
Interface Cards
6-49