Xerox DocuPrint N3225 System Administrator Manual page 79

Table 1.22 Ethernet Menu functions (continued)
Menu Item and Function
Port Timeout
Set the time for determining when to
end an incomplete print job and poll
the next port in the polling sequence.
The available values are:
5 - 300 seconds (30*)
This item also causes an implicit job
end such as Control D in PostScript or
<ESC> E in PCL, and invokes the
emulation functions associated with
this action (e.g., formfeed, reset, etc.).
The time changes incrementally by 1
second each time either Value Up
or Value Down is pressed.
Holding down Value Up
causes continuous scrolling
Down
through the values.
Speed
Set the speed of the 10/100 Ethernet
interface. The available values are:
Auto*
10/Half
10/Full
100/Half
100/Full
This item does not appear when
the 10Base2 Ethernet Interface is
installed.
Keystrokes
1. Press Menu Up
Down until you see:
2. Press Item Up
Down until you see:
3. Press Value Up
Down until you see:
4. Press Enter
5. Press On Line
or Value
1. Press Menu Up
Down until you see:
2. Press Item Up
Down until you see:
3. Press Value Up
until you see:
Down
4. Press Enter
5. Press On Line
Using the Menu System
or Menu
Menus
Ethernet Menu
or Item
Ethernet Menu
Port Timeout
or Value
Port Ti meo ut
New Value
. You will see:
Ethernet Menu
Port Timeout
. You will see:
Ready
or Menu
Menus
Ethernet Menu
or Item
Ethernet Menu
Speed
or Value
Spee d
New Value
. You will see:
Ethernet Menu
Speed
. You will see:
Ready
Table 1.22 Page 12 of 12
Chapter 1: Configuring the Printer
Display
=
=
1-71