Control Panel Messages
Table 5.2
Control Panel messages and corrective actions (continued)
Message
†
0102
-DIMM2
† Appears in the upper left
corner of the display.
†
0103
-DIMM3
† Appears in the upper left
corner of the display.
†
1000
-IOT
† Appears in the upper left
corner of the display.
†
2000
-XIE RAM
†
2010
-XIE PWPM
†
2020
-XIE VDMA
† Appears in the upper left
corner of the display.
†
3000
-Token Ring
† Appears in the upper left
corner of the display.
5-8
System Administrator Guide
Description/Corrective Action
A fault condition has occurred in DIMM 2.
1. Power OFF the printer.
2. Remove and reinstall DIMM 2.
3. Power ON the printer.
4. If the error code is re-displayed, replace DIMM 2.
Refer to Figure 5.1 on page 5-29 for location of memory board.
A fault condition has occurred in DIMM3.
1. Power OFF the printer.
2. Remove and reinstall DIMM 3.
3. Power ON the printer.
4. If the error code is redisplayed, replace DIMM 3.
Refer to Figure 5.1 on page 5-29 for location of memory board.
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred in the Token Ring interface. Power OFF the
printer and reset the interface card. Power ON the printer. If this code
appears again at Power ON, contact your Customer Support Center.
Table 5.2 Page 4 of 24