Precautions - Xerox DocuPrint N3225 System Administrator Manual

Precautions

Printer options are easy to install, however before you
attempt to install (or remove) any printer options, please
read and observe the following precautions.
• TWO PEOPLE ARE REQUIRED WHEN LIFTING OR
CARRYING THE PRINTER: The weight of the main unit
without paper cassette, consumables, and paper is about
99 lbs. (45 kg). Never attempt to lift the printer by
yourself. The printer should always be carried by two
people.
• POWER OFF THE PRINTER: The printer determines which
options are installed through a self-test. The self-test is
run when you power ON the printer. Therefore, for
proper operation, you must power OFF the printer before
installing/removing an option, then power it back ON
after installing/removing an option.
• DISCONNECT THE GFI POWER CORD: Never remove the
printer controller board while the printer is plugged in.
To avoid the possibility of electrical shock, always
disconnect the power cord when installing or removing
ANY internal or external printer option.
• DISCHARGE STATIC ELECTRICITY: The controller board
and internal printer options (DIMMs, Hard Disk Drive)
are sensitive to static electricity. Before installing or
removing an internal option, discharge static electricity
from your body by touching something metal, such as
the metal back plate on any device plugged into a
grounded power source. If you walk around before
finishing the installation, again discharge any static
electricity.
Chapter 6: Installing and Removing Printer Options
Precautions
6-3