Output Destination - Xerox DocuPrint N3225 System Administrator Manual

Using the Finisher

Output Destination

With a finisher installed, the user may select the following
output destinations: Face-down Bin, Face-up Bin, Finisher
Bin 1, Finisher Bin 2, and Finisher Bin 3. Output
destination can be set via the System Menu at the UI or by
PCL and PJL commands. See Table 2.4 on page B-7.
Output Bin Sensing
Each finisher bin senses not only the height of each stack,
but also the number of stapled sets delivered to each
stack. When the number of stapled sets delivered to the
bin reaches 100 for long edge feed (LEF) paper sizes, or 50
for short edge feed (SEF) paper sizes, as shown in
Table 1.36 on page 1-127, the bin is reported as full.
Bin Level Sensors
Finisher ensors can detect the following bin conditions:
s
• Empty
• 50%
• Full
When a bin is full and the stack height does not allow
additional sets to be sent to it, the destination of
additional sets directed to the full bin is determined by
the Output Timeout system parameter in the printer's
System Menu. See Table 1.14 on page 1-36.
Chapter 1: Configuring the Printer 1-125