Hard Disk Drive
Installing
6-36
System Administrator Guide
Follow the procedure below to install the Hard Disk Drive.
1
Power OFF the printer.
2
Disconnect the GFI power cord from the printer.
Discharge any static electricity from your
body before continuing with the next step.
3
Loosen the thumbscrews and pull out the controller
board.
4
Insert the four support posts as follows:
A
Push the two long posts up through the controller
board from the bottom.
B
Insert the two short posts into the holes in the top of
the controller board by inserting them at a 45° angle
and then rocking them forward.