Configure The Energy Save Modes Of The Océ Colorwave 600 - Oce ColorWave 600 User Manual

Configure the energy save modes of the Océ ColorWave 600
Introduction
The Océ ColorWave 600 offers two energy save modes that you can set if the printer is
idle for a defined period. The configuration of the timers prevents unnecessary power
consumption. You can adjust the value of the timers.
When to do
Sleep mode timer (Default value 1 hour).
The Océ ColorWave 600 uses minimal energy, because the power supply of the printer
is turned off. The power supply of the embedded Océ ColorWave 600 controller ('Océ
PowerM controller' / 'Océ PowerM Plus controller ') remains on. The printer needs to
warm up when it wakes up from the sleep mode.
Energy save mode timer (Default value 15 minutes).
Both the printer and the Océ ColorWave 600 controller remain turned on. The Océ
ColorWave 600 uses less energy than in normal operating mode, but the printer uses
more energy than in sleep mode. The advantage of the energy save mode over the sleep
mode is that the printer usually needs just a few seconds to wake up. Only when the
printer has not been used for more than 1 hour does the printer need more time to wake
up.
Note:
The value you set for the sleep mode timer must be higher than the energy save mode
value. If the value of the sleep mode is lower than the energy save mode, the printer skips
the energy save mode and goes into sleep mode. The power consumption will be lower
but it will also take the printer a bit longer to wake up again.
How to configure the time-out value of the energy save modes
Click 'Preferences' - 'System properties'.
1.
Click 'Edit' in the 'Printer properties' bar or click the value of the 'Sleep mode time-out'
2.
setting or the 'Energy saving mode time-out' setting.
Enter a new value in the Edit window and click 'Ok' to confirm your entries or 'Cancel'
3.
to reject your entries.
Note:
If you access the Edit window by clicking the value of the setting you want to change,
the Edit window displays the minimal and maximal value you can select.
Configure the energy save modes of the Océ ColorWave 600
Chapter 4 - Configure the printing system 123