Configure The Energy Save Modes Of The Océ Colorwave - Oce ColorWave 600 User Manual

Configure the energy save modes of the Océ ColorWave
Configure the energy save modes of the Océ ColorWave
600
Introduction
The Océ ColorWave
is idle for a defined period. The configuration of the timers prevents unnecessary
power consumption. You can adjust the value of the timers.
When to do
Sleep mode timer.
The Océ ColorWave
printer is turned off. The power supply of the embedded Océ ColorWave
controller ('Océ PowerM controller' / 'Océ PowerM Plus controller ') remains on. The
printer needs to warm up when it wakes up from the sleep mode.
Energy save mode timer.
Both the printer and the Océ ColorWave
™
ColorWave
uses more energy than in sleep mode. The advantage of the energy save mode over
the sleep mode is that the printer needs just a few seconds to wake up.
Note: The value you set for the sleep mode timer must be higher than the energy
save mode value. If the value of the sleep mode is lower than the energy save mode,
the printer skips the energy save mode and goes into sleep mode. The power
consumption will be lower but it will also take the printer a bit longer to wake up
again.
How to configure the time-out value of the energy save modes
Click 'Preferences' - 'System defaults' - 'Timers'
1.
Click the value you want to change or click 'Edit' in the 'Timers' bar.
2.
Enter a new value in the Edit window and click 'Ok' to confirm your entries or
3.
'Cancel' to reject your entries.
Note: If you access the Edit window by clicking the value of the setting you want to
change, the Edit window displays the minimal and maximal value you can select.
Note: When the Océ ColorWave
ways to activate the system.
press a key on the printer operator panel.
■
send a job.
■
106 Chapter 4 Configure the printing system
™
600 offers two energy save modes that you can set if the printer
™
600 uses minimal energy, because the power supply of the
600 uses less energy than in normal operating mode, but the printer
™
600 is in the energy save mode, there are three
™
600
™
600 controller remain turned on. The Océ
™
™
600