Settings; Set The 'Automatic Roll Switch - Oce ColorWave 600 User Manual

Set the 'Automatic roll switch'

Introduction
You can choose one of following values.
• 'Enabled'
Select this value if you have two or more media rolls that contain identical media (the
same media type and media size). In that case, the printer can automatically switch
to an alternative media roll when a roll runs out of media and continue printing.
• 'Disabled'
Select this value if all media rolls contain different media types or media sizes.
There are two options:
If you select a specific roll number for your print job and the selected media roll runs
out of media, the printing process stops.
If you did not select a specific roll number for your print job, but only a media type
and a media size, the printer automatically selects the roll that contains the required
media type and size.
Before you begin
This setting is editable for the Key operator or Power user.
How to set the 'Automatic roll switch'
Click 'Preferences' - 'System properties'.
1.
Click 'Edit' in the 'Printer properties' bar or click the value of the 'Automatic roll switch'
2.
setting.
Select the correct value.
3.
Select 'Enabled' if print productivity is an important factor.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
4.
Set the 'Automatic roll switch'
Chapter 8 - Print quality and Print productivity 327