Calibration Error Codes; Codes - Oce ColorWave 600 User Manual

Calibration error codes

Introduction
Before or during the calibration, it is possible that the calibration failed. In that case, you
will be informed immediately through an error code on the 'Printer operator panel'.
Attention:
Error-codes are only displayed at the 'Printer operator panel'. If an error code is displayed
that is not related to the calibration process, the user must follow the instructions on the
printer operator panel to solve the problem.
Note:
For feedback about errors related to the processing of print jobs open the event list in
the 'Jobs' tab.
Overview calibration error codes
#
Error-code
22917
22918
22919
22920
22921
22922
22923
22924
22925
Action
Calibration not accepted:
Calibration not accepted:
Calibration not accepted:
Calibration not accepted:
Calibration not accepted:
Calibration not accepted:
Calibration not accepted:
Calibration failed:
Calibration failed:
Chapter 8 - Print quality and Print productivity
Calibration error codes
Remarks
Roll not loaded
Roll too small
Media type not suitable for instal-
lation calibrations
Media type not suitable for Y-
alignment
Media type not suitable for pa-
per step calibration
External output not available for
delivery
Printer engine status is not
standby or the folder (if config-
ured) is offline or turned off
Out of toner during calibrations
Out of media during calibrations
385