Oce ColorWave 600 User Manual page 270

'Advanced' / 'Layout' settings
You can change the alignment of the image on the media.
The reference is the image displayed in the 'Print Preview'. You can immediately check
the effect of the adjustment in the preview.
Activate the option and type in a value:
• In the 'Horizontal' field, a positive value shifts the image to the right of media.
A negative is a shift to the left
• In the 'Vertical' field, a positive value shifts the image to the bottom of media.
A negative value shifts it to the top.
Check the result of the shift in the 'Print Preview'.
You can set this value when you selected a 'Sheet size' or a 'Tray size', or 'Manual feed'
as the 'Media size'.
'Add margins around the image'
Note:
This option is available on the Océ ColorWave 600 and Océ ColorWave 600 PP systems.
Define whether the image to be printed needs additional margins. The additional margins
compensate for the non-printable area on the media.
If there are no margins (white space) arranged in the print file, select the 'Add margins
around the image' option.
This option adds an additional margin to each side of the print content in order to avoid
cropping. It increases the size of the output.
Check the result in the'Print Preview' and adjust the media size in case of cropping.
You can configure the size of these added margins in the printer configuration tool: from
3mm (default) up to 5mm (0.12 to 0.19 inch).
It is recommended to select this option when:
• the content of the print file covers 100% of the file (no border) and the size of the
image is the same as the size of the selected media.
• the content of the print file covers 100% of the file (no border) and the image is
smaller than the selected media.
270 Chapter 6 - The Océ Publisher Copy option