Oce ColorWave 600 User Manual page 138

Set the default print job settings
#
Setting
'Media source'
'Media selection policy'
'Print cut method'
'Custom print length'
'Add leading strip'
'Add trailing strip'
Overview of the 'Print job defaults' - 'Layout'
Editable for Key operator and Power user.
'Preferences' - 'Print job defaults' - 'Layout'
138 Chapter 4 - Configure the printing system
Description
The 'Media source' setting can be used to select the default
output material and format. The 'System' screen of the
printer operator panel will show you what rolls are currently
loaded.
You can select 'Automatic' or you can select a specific roll
number that the Océ ColorWave 600 must use by default.
If you select 'Media source': 'Automatic' you can also set
the 'Media selection policy' setting.
When you select 'Automatic next larger' the printer auto-
matically selects the media roll with the exact media size
for your print job. If the media roll with the exact media
size is not available the next larger media roll on the printer
is selected.
When you select 'Automatic exact fit' the printer automat-
ically selects the media roll with the exact media size for
your print job. If the media roll with the exact media size
is not available a media request pops up.
• Select 'Standard' to cut the print to a standard media
size (DIN, ANSI, ...)
• Select ''Synchro':' to cut the print at the end of the im-
age. The system cuts at the measured length of the
original times the scale factor.
• Select ''Custom':' (numeric) to cut the print on a speci-
fied length. The print length is defined by value of the
setting 'Custom print length'.
Print length if the 'Print cut method' is set to ''Custom':'.
When you enter a value, the Océ ColorWave 600 adds a
blank strip of the specified length at the beginning of the
output.
When you enter a value, the Océ ColorWave 600 adds a
blank strip of the specified length at the bottom of the
output.