Configure The Media Sizes - Oce ColorWave 600 User Manual

Configure the media sizes

Introduction
You must indicate in the Océ Express WebTools the following settings.
• The core size of the media rolls
• The media sizes
How to define the core size of the media
Attention:
Access the Océ Express WebTools. This setting is editable for the Key operator and the
Power user.
Navigate to 'Configuration' - 'Printer setup'.
1.
Click 'Edit' in the 'Media' bar or click the value of the 'Two-inch core used' setting if
2.
you also use 2 inch cores.
The standard roll core size for the Océ ColorWave 600 is 3 inch. If you also use media
rolls with 2 inch cores the Océ ColorWave 600 must do some internal adjustments to
also support these media.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
3.
How to define the media sizes
Attention:
Access the Océ Express WebTools. This setting is editable for the System Administrator
and the Power user.
Navigate to the 'Support' - 'Media' tab.
1.
Click on the value of the 'Supported media sizes' setting. A new window opens.
2.
Select the media series from the drop-down list. For each of the standard media series
3.
('ANSI small', 'DIN', 'ANSI mixed' or 'DIN Carto') a set of media sizes is enabled as
indicated in the table below. You can enable or disable media sizes to tune the system to
your environment. The media series will then automatically change into a 'Custom' media
series.
Configure the media sizes
Chapter 4 - Configure the printing system 125