Fold A Job - Oce ColorWave 600 User Manual

Fold a job

Fold a job
Introduction
When folding is enabled, Océ ColorWave 600 analyses the values set in the selected
template, the 'Image Properties', the size and the 'Layout' information of each image to
define the orientation of the image on the media.
It displays a preview of the image in the 'Print Preview' to show:
• The position of the image in the selected media
• The feed direction
• the part of the image that will be placed on top of the folded packet (in gray), when
folding is activated
The goal is to deliver a folded output that displays the legend on top of the folded packet.
Note:
Check the configuration of the default template for folding: set the default CAD or
reading orientation and activate the 'Automatic detection of the legend' (with adequate
timeout) in the template 'Image' settings.
Adjust the settings for folding
In some cases, it occurs that the part of the image located on top of the folded packet
displayed in the preview does not match the legend position.
Fine tune some settings until you can see in the 'Print Preview' that the part of the image
shown as top of the folded packet contains the legend:
• In 'Image Properties' select the suitable 'Reading orientation'.
Select 'Add a 180 degrees extra rotation' and adjust the position of the legend if
needed.
• If needed, in the 'Basic' settings, select a different 'Media size'.
Special cases
The system displays an error message and prevents printing when:
• The selected media roll is wider than 36 inches ('The selected media size cannot be
folded.')
• The media type cannot be folded ('The selected media type cannot be folded.')
276 Chapter 6 - The Océ Publisher Copy option