Set The 'Print While Rip' Setting - Oce ColorWave 600 User Manual

Set the 'Print while RIP' setting

Introduction
This setting is a performance optimization setting. When "Print while RIP" is enabled,
for Economy prints, the printer starts to print an image during the rasterization of the
image. Occasionally the rasterization of the image cannot keep up with the print speed.
In that case the print process will be aborted (error code 22801) and the print will be re-
covered afterwards. To prevent this you can disable this setting. Even when disabled, the
printer still starts to print rasterized pages before all pages of a job are rasterized.
You can choose one of following values.
• 'Enabled'
This is the default setting.
• 'Disabled'
Select this value if you often encounter error code 22801.
Before you begin
This setting is editable for the Key operator or Power user.
How to set the 'Print while RIP' setting
Click 'Preferences' - 'System properties'.
1.
Click 'Edit' in the 'Printer properties' bar or click the value of the 'Print while RIP' setting.
2.
Select the correct value.
3.
Select 'Enabled' if print productivity is an important factor.
Click 'Ok' to confirm your entries or 'Cancel' to reject your entries.
4.
Set the 'Print while RIP' setting
Chapter 8 - Print quality and Print productivity 329