Set The Océ Tcs500 Printer Timers; The Energy Save Mode Timer - Oce TCS500 User Manual

The energy save mode timer

Set the Océ TCS500 printer timers
The energy save mode timer
Introduction
The Océ TCS500 printer has 2 modes to prevent unnecessary power consumption.
The energy save mode.
The sleep mode.
This section describes the energy save mode.
The energy save mode
The Océ TCS500 printer uses less energy in the energy save mode than in the normal
operating mode.
Both the printer and the Océ Power Logic
You can define the following energy save mode settings in the Océ Setting Editor.
[22]
[22] Energy save mode settings in the Océ Setting Editor
Key Operator - Printer - Settings -
Timers - Energy save mode timer
enable - Energy save mode timer
Enabled
Disabled
Note: By default, the 'Energy save mode timer' is enabled and the 'Energy save
mode time-out' is set to 5 minutes.
If you must change the default settings in the Océ Settings Editor proceed as follows.
58 Chapter 3 Prepare the Océ TCS500 for use
®
controller remain turned on.
Key Operator - Printer - Settings -
Timers - Energy save mode time-out
Use this setting to define the delay in
minutes before the Océ TCS500 printer
enters the energy save mode.
Not applicable