Stapler Faults - Xerox 4110 User Manual

Stapler Faults

X e r o x 4 11 0 / 4 5 9 0 U s e r G u i d e
This section explains the problems that may arise from stapling.
Perform the procedures on the following pages when copies are
not stapled or when staples are bent. Contact the Customer
Support Center if the problem persists after you have tried these
solutions.
Unstapled Unstapled
If staples are stapled on the copies in the manner shown in the
illustrations, contact the Customer Support Center.
One side of staple rising up
Flattened staple
KEY POINT: Remove the bent staple when opening the staple
cartridge cover. If you do not remove the bent staple, a
staple jam may occur as a result. Use the staple cartridge
cover only when removing the bent staple.
1 2 . P r o b l e m S o l v i n g
Bent staple
Staple bent in reverse direction
Entire staple rising up
Staple rising up with
center pressed in
12-83