Xerox 4110 User Manual page 411

Category
Error Code
C P S M O
016-713
016-714
016-716 %
016-718 %
016-719 %
016-720 %
016-721 %
016-722
%
016-723 %
016-728 %
016-729 %
X e r o x 4 11 0 / 4 5 9 0 U s e r G u i d e
% Cause The password set to the mailbox and the inputted
password were not in agreement.
Remedy Enter the correct password.
% Cause Specified mailbox did not exist.
Remedy Create a mailbox or specify the existing mailbox.
Cause Unable to spool TIFF file because of insufficient disk
space.
Remedy Remove unnecessary documents and users stored on
the printer and then attach the hard disk. When attaching
a hard disk, contact the Customer Support Center.
Refer to "Deleting Documents in the Scan & Other Jobs Mailbox" on
page 5-71.
Cause PCL print data could not be processed as there was
insufficient memory.
Remedy Reduce resolution, cancel 2 Sided printing or N up, and
try to print again.
Cause PCL print data could not be processed as there was
insufficient memory.
Remedy Increase the size of the print page buffer.
Cause The PCL print data included a command which cannot
be processed.
Remedy Confirm the print data and try to print again.
% Cause An error occurred during print processing. Probable
causes are as follows:
1. Printing was instructed by Automatic Tray
Selection when Paper Type Priority is set to
Automatic Tray switching Off for all paper in the
Common Settings.
2. ESC/P command error
Remedy For 1, when printing by Automatic Tray Selection, set
one of the paper types to a setting other than
Automatic Tray switching Off in Paper Type Priority.
For 2, check print data.
Refer to "Paper Type Priority" in the System Administration Guide.
Cause Unsupported staple position is specified.
Remedy Confirm the position, and specify the print data again.
Cause Unsupported punch position is specified.
Remedy Confirm the position, and specify the print data again.
Cause An unsupported tag was included in the TIFF file.
Remedy Check the print data.
Refer to "Scan Options" on page 4-35.
Cause Unable to print because the number of colors/resolution
of the TIFF file exceeds the allowed range.
Remedy Change the number of colors/resolution for the TIFF file,
and specify the print data again.
Refer to "Scan Options" on page 4-35.
1 2 . P r o b l e m S o l v i n g
Cause and Remedy
12-35