Cleaning The Document Cover And Document Glass - Xerox 4110 User Manual

11 . M a i n t e n a n c e
NOTE: If it is difficult to remove dirt, try gently wiping with a soft
cloth moistened with a small amount of neutral detergent.
2.
Wipe off any excess water from the exterior with a soft cloth.

Cleaning the Document Cover and Document Glass

Cleaning the document cover and glass on a regular basis is
important to providing the best image quality possible on your
printed or copy output. If the document cover and document glass
are dirty, spots may appear on copies and the machine may not
properly detect document sizes. This is why it is important to
regularly clean the document cover and glass.
NOTE: Occasionally the machine may display a message stating
that "The Scanner may be dirty. See User Guide or label
instructions on the Document Feeder to wipe the scanning
glass." If you get this message, perform the cleaning procedure
for the document cover and document glass.
When performing the cleaning procedure, it is recommended that
you clean all the components of the document cover and glass at
the same time. These components consist of the document cover,
the document (platen) glass, and the second-side scanning lens
assembly.
To clean all three of these components, use the following
procedure.
CAUTION: Do not use benzene, paint thinner, or other organic
solvents as they may damage the paint or coating on the plastic
parts.
CAUTION: Do not use an excessive amount of water to clean the
machine as this may cause the machine to malfunction or may
damage documents during the copy process.
X e r o x 4 11 0 / 4 5 9 0 U s e r G u i d e
11-15