Xerox 4110 User Manual page 383

Symptoms
Paper is often
jammed or
wrinkled.
Documents are
not fed into the
document
feeder.
An error
message is
displayed after
paper is loaded
in paper Tray 5
(Bypass) and the
Start button is
pressed.
X e r o x 4 11 0 / 4 5 9 0 U s e r G u i d e
Check
Is paper loaded properly in
the paper tray?
Is the paper tray set
properly?
Is the paper damp?
Is the paper curled?
Are the paper and paper
tray settings correct?
Are there any torn pieces of
paper still remaining inside
the machine or is there a
foreign object in the
machine?
Is out-of-spec paper loaded
in the tray?
Is paper loaded in the paper
tray past its maximum fill
line?
Is the paper guide set
correctly?
Are the documents too
small?
Check the position of the
paper guides at the front
side of paper Tray 5
(Bypass).
Remedy
Load paper correctly.
Refer to "Loading Paper in Trays 1 to 2" on
page 8-5.
Firmly push in the paper tray as far as
possible to set it properly.
Refer to "Loading Paper in Trays 1 to 2" on
page 8-5.
Replace with paper from a new ream.
Refer to "Loading Paper" on page 8-4.
Either turn the paper so that the curl is
facing down in the paper tray, or replace
with paper from a new ream.
Refer to "Loading Paper" on page 8-4.
Make sure the paper and paper tray match
the configured paper size.
Refer to "Paper Tray Settings" in the
System Administration Guide.
Open the door of the machine or slide out
the paper tray to remove the torn paper or
the foreign object.
Refer to "Paper Jams" on page 12-47,
"Loading Paper" on page 8-4.
Replace with paper that meets machine
specifications.
Refer to "Loading Paper" on page 8-4.
Load paper in the paper tray so that it does
not exceed the maximum fill line.
Refer to "Loading Paper in Trays 1 to 2" on
page 8-5.
Load the paper correctly, and apply the
paper guides lightly.
Refer to "Loading Paper" on page 8-4,
"Changing the Size of Paper in Trays" on
page 8-14.
The minimum size of the document that
can be loaded on the document feeder is
A5 and 5.5 X 8.5."
Refer to "Step 1 Loading Documents" on
page 3-2.
Set the paper guides to the correct
positions.
Refer to "Loading Paper in Tray 5
(Bypass)" on page 8-7.
1 2 . P r o b l e m S o l v i n g
12-7