What The Led Means; In Case Of A Jam In The Paper Path Or Stapler; Making A Booklet; To Make A Booklet - Xerox Nuvera User Manual

How Do I...
2. When the LED is blinking, open the tray access door.
3. Grasp the black handle and slide tray outward.
4. Remove stack from stacker tray.
5. Push tray back into the BFM.
6. Close the access door.

What the LED means

• LED is On = BFM is in use
• LED is Off = BFM is not in use or is initializing after an unload (Do not open BFM front door)
• LED is Steady = Stacker tray is lowering (Do not open BFM front door)
• LED is Blinking Slow = Stacker tray is lowering for an unload and the request to open the BFM front
door is recognized
• LED is Blinking Fast = OK to open the BFM front door
Note
The Unload button will not cause an unload if the Feed Module runs out of paper in the middle of a
job. Fill the Feed Module tray and allow the set to finish. Canceling, holding, or deleting a job will also
allow unloading to occur.

In case of a jam in the paper path or stapler:

If paper should become jammed in the paper path section or stapler, and a system event does not
appear, you can access these areas by unlocking the drawer/cover through the system software.
1. In the system user interface, click Printer > Unlock Finisher.
The Unlock Basic Finisher window appears.
2. The Top Cover and Stapler Drawer unlock buttons are shown. Click the button of the area you wish
to unlock.
3. You should hear a series of clicks coming from the BFM.
The cover or drawer can now be accessed.
Caution
Do NOT attempt to unlock any BFM covers or drawers while there is still an "Adjusting Finisher" status
visible in the status area of the system user interface. Wait for this message to clear before attempting
to use the Unlock Basic Finisher controls.
For details on clearing papers jams in the BFM, see

Making a Booklet

Those Xerox Nuvera systems with a Multifunction Finisher (MFF) offer booklet making capabilities.
For details about the Multifunction Finisher, see

To make a booklet

Multiple-page documents can be arranged in a folded and bound output, most commonly called a
booklet. The Xerox Nuvera allows you to set up a booklet output job in a few different ways.
Two conditions must be in place in order to process a booklet job:
14-12
Clearing Paper Jams.
Multifunction Finisher (MFF) Specifications.
Xerox ® Nuvera
User Guide and Training Aid (UGTA)
®