Connecting Cables To The Rmx 2000 - Polycom 1500 Deployment Manual

•

Connecting Cables to the RMX 2000

Do not remove the protective caps from LAN1, LAN3 and ShMG ports.
Connect the following cables to the back panel:
•
•
•
•
Polycom, Inc.
Using a shelf:
— Install the shelf, supplied by the rack manufacturer, in the rack.
— Mount the RMX on the shelf.
— Fasten the RMX to the rack with screws through the four holes in the RMX's front
mounting brackets.
Power cable
On the RTM IP card connect the LAN cable to LAN 2 Port.
On the RTM LAN card connect the LAN cable to LAN 2.
— Optional. Connect the LAN cable to LAN 1.
With Multiple Networks and LAN Redundancy configurations, LAN 1 port is used.
For more information, see the RealPresence® Collaboration Server Administrator's
Guide, "LAN Redundancy" on page
page 16-49.
Optional. On the RTM ISDN card connect the E1/T1 Cables to PRI Ports.
LAN 2 Connection
16-32 "Multiple Network Services" on
and
LAN 2 Connection, (optional) LAN1
E1/T1 Connection
Chapter 1-First Time Installation and Configuration
Power
Off/On
switch Cable
1-15