Realpresence® Collaboration Server (Rmx) Hardware; Installation And Configuration - Polycom 1500 Deployment Manual

RealPresence® Collaboration Server (RMX) Hardware
It is required that MPM+ or MPMx cards are installed in the RMX.

Installation and Configuration

First Time Installation and Configuration of the RMX 1500/2000/4000 consists of the
following procedures:
1
2
3
4
5
6
7
8
9
10 Rename the default POLYCOM user
11 Disable Inline AutoComplete Option in Web Browser
12 Configure an Inbound and Outbound Access List
Polycom, Inc.
information see the RealPresence Collaboration Server (RMX) 1500/2000/4000
Administrator's Guide "Certificate Configuration and Management" on page
Hardware Installation and Setup
— Mount the RMX in a rack.
— Connect the necessary cables.
Gather Network Equipment and Address Information
— Get the information needed for integrating the RMX into the local (Signaling and
Management) networks.
First Entry Configuration
— Register the RMX.
— Power up the RMX.
— Modify the Default Management Network.
— Configure the Signaling Network Service.
— Configure the ISDN/PSTN Network Service.
Enable Ultra Secure Mode
Enable Secured Communication
— Purchase and Install the SSL/TLS certificate
— Modify the Management Network settings
— Create/Modify the relevant System Flags
Set System Configuration Flags
Enable Network Separation (RMX 2000)
Configure IVR Settings
Modify Default Login Banner Text (if required)
Chapter 1-First Time Installation and Configuration
F-1.
1-3