Assigning A Charge Pager Number (Menu, 5, 6); Figure 3-27: Assigning A Charge Pager - Dukane 4A3610B Operation Manual

Assigning a Charge Pager Number (MENU, 5, 6)

ProCare 6000 Operation Manual
This menu selection allows you to designate a pager as a charge pager. This pager is al-
ways given to the charge person on each shift. It is paged any time a call is still pending
after two timeout periods.
Notes:
If your system has version 4.XX video displays, use the video display to perform
•
this function instead of the base master.
If your system has version 5.XX video displays, no assignment functions can be
•
performed using the base master or the video display software. ProCare 6000
Systems with 5.XX video displays use MatchMaker ip software to assign pagers.
See the MatchMaker ip User Guide.
1. Press MENU.
2. Press 5 to select Pocket Page = 5.
3. Press 6 to select Charge Pager# = 6. "Waiting for Data" appears, then "OldPager#,"
then "NewPager# _ _ _ _ _." See Figure 3-27.
Note:
You can review the old charge pager number by pressing VOL up. Then press VOL
down to return to Figure 3-27 before proceeding.
NewPager# > _ _ _ _ _

Figure 3-27: Assigning a Charge Pager

4. Enter the charge pager number and press *ANS.
a. "Waiting for Data" and "Waiting for Resp" appear briefly.
b. If the pager number is valid, an acceptance tone sounds (two rapid, high pitch
tones).
c. If the pager number is invalid, an error tone sounds (two rapid, low pitch tones).
Re-enter the number.
5. Press #CNCL repeatedly to exit the menu and return to the normal display. If you do
not, the base master automatically exits the menu after a programmed interval.
Performing Pocket Page Functions (MENU, 5)
3-25