Assigning Alternate Staff (Menu, 3, 2); Figure 2-9: Old Alternate Staff Assignment - Dukane 4A3610B Operation Manual

Assigning Alternate Staff (MENU, 3, 2)

ProCare 6000 Operation Manual
Assigning Staff to a Station While Connected to a Call
5. Enter the new staff assignment. If the ID number is shorter than the number of digits
shown on the display, press *ANS.
a. "Waiting for Resp" (response) appears briefly.
b. The call reappears in the display followed by TALK.
6. Press #CNCL or replace the handset to end the call.
Follow these steps to assign an alternate staff member to a station while connected to the
station. Your base master must "possess" the station by covering it, swinging it, or cap-
turing it before you can change the assignments.
Notes:
If your system has version 4.XX video displays, use the video display to perform
•
this function instead of the base master.
If your system has version 5.XX video displays, no assignment functions can be
•
performed using the base master or the video display software. ProCare 6000
Systems with 5.XX video displays use MatchMaker ip software to assign staff.
See the MatchMaker ip User Guide.
1. Connect to the station either by answering their call or by calling them. (See pages
2-2 and 2-3, and pages 2-4 and 2-5.)
2. Press MENU.
3. Press 3 to select Staff Assign = 3.
4. Press 2 to select BedTo AltStaff = 2.
The current staff ID number appears (Figure 2-9), followed by a prompt for the new
staff ID number (Figure 2-10 on the next page).
Note:
To review the old staff assignment, press VOL up. Then press VOL down to return to
Figure 2-10 on the next page before proceeding to step 5 on the next page.
oAsID#>

Figure 2-9: Old Alternate Staff Assignment

2222
continued
2-7