Swinging a Station to Your Base Master (MENU, 3, 3, 1)
ProCare 6000 Operation Manual
3. Press 2 to select Assign Staff = 2.
StafId>
Figure 3-17: Creating Staff IDs
4. Press 3 to select Create StaffID = 3. Figure 3-17 appears:
5. Enter the new staff ID number. If the number is shorter than the number of spaces
in the display, press *ANS. "Waiting for Data" and "Waiting for Resp" (response)
appear briefly, then an acceptance tone sounds and the base master returns to
Figure 3-17.
6. Press #CNCL repeatedly to exit the menu and return to the normal display. If you do
not, the base master automatically exits the menu after a programmed interval.
This menu selection allows you to temporarily "swing" a station's coverage from another
base master to your base master, so that you will received calls placed from that station.
Notes:
This is a temporary coverage, until another base master swings the station away.
•
Permanent coverage is not affected by swing operation.
Only designated swing stations should be "swung" in this manner. These stations
•
should be recorded in the Designated Swing Stations Chart on page 3-15.
To assign a swing station to a different duty area, see Swinging a Station to a Duty
•
Area on page 3-14.
1. Press MENU.
2. Press 3 to select Assignments = 3.
3. Press 3 to select Assign Swing = 3.
4. Press 1 to select SwingBedToMstr = 1. Figure 3-18 appears:
Bed#ToM>
Figure 3-18: Assigning Swing Stations to a Base Master
Assigning Base Masters, Staff, and Stations (MENU, 3)
_ _ _ _ _
_ _ _ _ _
continued
3-13