Creating Staff Ids (Menu, 3, 2, 3); Figure 3-16: New Alternate Staff Display - Dukane 4A3610B Operation Manual

Assigning Base Masters, Staff, and Stations (MENU, 3)

Creating Staff IDs (MENU, 3, 2, 3)

3-12
5. Enter the station number. If the number is shorter than the number of spaces in the
display, press *ANS.
a. The old alternate staff number appears briefly (oAsID#), then the prompt for the
new staff number (nAsID# _ _ _ _ _ _). See Figure 3-16.
b. You can press VOL up to review the station number and old alternate staff ID.
Then press VOL down to return to Figure 3-16 before proceeding.
nAsID#>

Figure 3-16: New Alternate Staff Display

6. Enter the new alternate staff number. If the ID is shorter than the number of digits
shown on the display, press *ANS.
a. "Waiting for Data" and "Waiting for Resp" (response) appear briefly.
b. If the staff ID is valid, an acceptance tone sounds and the base master returns to
Figure 3-15 on the preceding page. Either repeat steps 5 and 6 to assign more staff,
or go to step 7 to end.
c. If the staff ID is invalid, an error tone sounds and the base master returns to
Figure 3-16. Repeat step 6. If "OwnerOut" appears, see page 2-23.
7. Press #CNCL repeatedly to exit the menu and return to the normal display. If you do
not, the base master automatically exits the menu after a programmed interval.
This menu selection allows you to create new staff IDs.
Note:
If your system has version 4.XX video displays, use the video display to perform
•
this function instead of the base master.
If your system has version 5.XX video displays, staff IDs are not used. ProCare
•
6000 Systems with 5.XX video displays use MatchMaker ip software to enter staff
names. See the MatchMaker ip Supervisor Guide.
This menu item must be enabled before you can access it on your base master. If you can-
not access this menu item, contact the proper authority to enable it. That person should
refer to Configuring the Special Program Feature in the ProCare 6000 System Installa-
tion and Configuration Manual.
1. Press MENU.
2. Press 3 to select Assignments = 3.
_ _ _ _
ProCare 6000 Operation Manual