Placing the Master On/Off Duty (MENU, 2)
ProCare 6000 Operation Manual
This menu selection allows you to place the base master on duty or off duty.
Notes:
Incoming calls still tone and display at an off duty base master. You can still place
and answer calls from an off duty base master. However, the base master will stay
off duty until it is placed on duty following the steps below.
The base master will tone at the volume level programmed for the on duty or off duty
state.
—CAUTION—
Placing a master off duty can affect pocket paging and system monitor operations.
However, taking a master off duty in systems equipped with MatchMaker ip and
MessageMaker ip software does not affect pocket paging or system monitor. Check
with your supervisor or administrator regarding your particular system.
1. Press MENU.
2. Press 2 to toggle the base master between on duty and off duty.
a. If the base master is on duty, a heartbeat flashes in the far right corner of the
display. See Figure 3-2.
b. If the base master is off duty, "Od" flashes at the far right. See Figure 3-3.
ProCare 6000
Figure 3-2: On Duty Idle Display
ProCare 6000
Figure 3-3: Off Duty Idle Display
Placing the Master On/Off Duty (MENU, 2)
Od
3-3