Paging Hallway Speakers from a Telephone
ProCare 6000 Operation Manual
1. Lift the telephone handset.
2. Enter the Telco extension number. (See the extensions on page 5-1.) A basic
telephone ring and a beep confirm that you have accessed the Telco. (If the Telco is
in use you will hear a busy signal.)
3. Press the star (*) key.
4. Enter the number of the paging speaker. A double beep confirms connection. (If an
error tone of two low pitch tones sounds, go to step 6, then try again.)
5. Speak into the handset to make your page.
6. To end your telephone session, press the pound (#) key twice to disconnect from the
Telco. A brief warble tone confirms disconnection.
—CAUTION—
You must press the pound (#) key TWICE to disconnect from the Telco. If you do
not, the Telco will be unusable until it times out.
Note:
If your facility has the newer Telco card (Model 110-3628B) and a PBX that supports the
Call Party Disconnect feature, you do not need to press the pound (#) key twice. You can
simply hang up the phone.
Paging Hallway Speakers from a Telephone
5-7