Placing a Call
Placing a Call
Placing a Call Using the Key Pad and Alpha Keys
2-4
Follow these steps to call a station using the base master's key pad and alpha keys. (Al-
pha keys are only used if the station number includes a letter; e.g., 101A.)
1. Using the key pad and alpha keys, enter the station number. The entered digits appear
in the display followed by "DIAL." If the number is shorter than the number of
spaces in the display window, press *ANS.
a. If the station number is invalid, the base master sounds an error tone and reverts
to the previous display.
b. If the station number is valid, "WAIT" appears briefly, followed by the connect
display (1011 TALK). See Figure 2-6.
Note:
If pending calls are in the system, the number of calls appears at the right. See
Figure 2-5 on page 2-3.
1011 TALK
Figure 2-6: Station Number Appearing in the Connect Display
2. Either press the TALK button to communicate with the station (and release it
to listen), or lift the handset to communicate privately with the station.
3. Press #CNCL or replace the handset to end the call.
ProCare 6000 Operation Manual