Assigning Alternate Staff To Stations (Menu, 3, 2, 2); Figure 3-15: Assigning Alternate Staff To A Station - Dukane 4A3610B Operation Manual

Assigning Alternate Staff to Stations (MENU, 3, 2, 2)

ProCare 6000 Operation Manual
6. Enter the new primary staff ID. If the ID is shorter than the number of digits shown
on the display, press *ANS.
a. "Waiting for Data" and "Waiting for Resp" (response) appear briefly.
b. If the staff ID is valid, an acceptance tone sounds and the base master returns to
Figure 3-13 on the preceding page. Either repeat steps 5 and 6 to assign more staff,
or go to step 7 to end.
c. If the staff ID is invalid, an error tone sounds and the base master returns to
Figure 3-14 on the preceding page. Repeat step 6. If "OwnerOut" appears, see
page 2-23.
7. Press #CNCL repeatedly to exit the menu and return to the normal display. If you do
not, the base master automatically exits the menu after a programmed interval.
This menu selection allows you to assign an alternate staff member to a station. The sta-
tion MUST be covered by your base master, either by capturing, by swinging, or by
coverage assignment.
Notes:
If your system has version 4.XX video displays, use the video display to perform
•
this function instead of the base master.
If your system has version 5.XX video displays, no assignment functions can be
•
performed using the base master or the video display software. ProCare 6000
Systems with 5.XX video displays use MatchMaker ip software to assign staff.
See the MatchMaker ip User Guide.
1. Press MENU.
2. Press 3 to select Assignments = 3.
3. Press 2 to select Assign Staff = 2.
A<-Bed#> _ _ _ _ _ _

Figure 3-15: Assigning Alternate Staff to a Station

4. Press 2 to select BedTo AltStaff = 2. Figure 3-15 appears:
Assigning Base Masters, Staff, and Stations (MENU, 3)
continued
3-11