Sending a Pocket Page While Connected to a Call
Paging Staff by Pager ID Number (MENU, 5, 4)
2-12
Follow these instructions to page a staff member by pager number, and transmit the sta-
tion number and an optional two-digit coded message relating to that patient.
Notes:
If your system has version 4.XX video displays, use the video display to perform
•
this function instead of the base master.
If your system has version 5.XX video displays, no pocket paging functions can be
•
performed using the base master or the video display software. ProCare 6000
Systems with 5.XX video displays use MessageMaker ip software to page staff.
See the MessageMaker ip User Guide.
1. Connect to the station either by answering their call or by calling them. (See pages
2-2 and 2-3, and pages 2-4 and 2-5.)
2. Press MENU.
3. Press 5 to select Pocket Page = 5.
4. Press 4 to select Page Pager ID# = 4. Figure 2-14 appears.
Pager # - > _ _ _ _ _
Figure 2-14: Pager Number Display
5. Enter the pager number of the staff member to be paged. If the number is shorter than
the number of spaces shown in the display, press *ANS. Figure 2-15 appears,
showing the station you are connected to:
Msg - >
Figure 2-15: Message Display Prompt
6. Enter the two-digit number of the pager message to be sent to the staff member. (See
Pocket Pager Messages on page 2-13.) To send the station number without a
message, press *ANS.
a. "Waiting for Resp" (response) appears briefly.
b. The page (station number and optional message) is sent to the staff.
c. The call reappears in the display followed by "TALK."
7. Press #CNCL or replace the handset to end the call.
1022 _ _
ProCare 6000 Operation Manual