Assigning Staff to a Station While Connected to a Call
Assigning Staff to a Station While Connected to a Call
Assigning Primary Staff (MENU, 3, 1)
2-6
Follow these steps to assign a primary staff member to a station while connected to the
station. Your base master must "possess" the station by covering it, swinging it, or cap-
turing it before you can change the assignments.
Notes:
If your system has version 4.XX video displays, use the video display to perform
•
this function instead of the base master.
If your system has version 5.XX video displays, no assignment functions can be
•
performed using the base master or the video display software. ProCare 6000
Systems with 5.XX video displays use MatchMaker ip™ software to assign staff.
See the MatchMaker ip User Guide.
1. Connect to the station either by answering their call or by calling them. (See pages
2-2 and 2-3, and pages 2-4 and 2-5.)
2. Press MENU.
3. Press 3 to select Staff Assign = 3.
4. Press 1 to select BedToPrimStaff = 1.
The current staff ID number appears (Figure 2-7), followed by a prompt for the new
staff ID number (Figure 2-8).
Note:
To review the old staff assignment, press VOL up. Then press VOL down to return to
Figure 2-8 before proceeding to step 5 on the next page.
oPsID#>
Figure 2-7: Old Primary Staff Assignment
nPsID#>
Figure 2-8: New Primary Staff Assignment
1111
_ _ _ _
continued
ProCare 6000 Operation Manual